Add the User's Credentials to Epiphany
Last updated
Last updated
These instructions, for the most part, apply to both Tenable.io and Tenable.sc. Steps that are unique for each application are clearly identified.
Step 1:
Log in to your Epiphany account.
In the left menu, expand Source Management and select Configuration.
Follow the steps in this section f you are using Tenable.io (cloud).
Expand Cloud and then expand Vulnerability Management.
Select Add New Datasource.
Select Teneable.io.
Follow the steps in this section if you are using Tenable.sc (on-prem).
Expand On-prem and then expand Vulnerability Management.
Select Add New Datasource.
Follow these steps for both Tenable.io and Tenable.sc.
On the Add New Datasource page, enter this information:
Data Source Name: a description of the Tenable account.
Data Source Owner: from the drop-down list, select the name of your Tenable admin.
Data Source Notes: any additional information about the account.
Access Key: the Access Key you obtained in Generate an API Key.
Secret Key: the Secret Key you obtained in Generate an API Key.
To see the Access Key and Secret key as you type them, check the Show Secret Key checkbox.
For Tenable.sc only:
IP/Hostname: IP address or host name for the Tenable data source.
Select Save.
The Add New Datasource page is the same for both Tenable.io and Tenable.sc, with this exception: Tenable.io doesn't include the IP/Hostname and Collector settings. The Collector setting is covered in Deploy a Site Collector (Tenable.sc only).
Select Tenable.sc.
